تعارف
The Samson PB15 Pro PowerBrite is a comprehensive rackmount power conditioner designed to provide clean, stable power to your audio equipment. It integrates power distribution, precise metering, and convenient lighting into a single 1U rack space unit. This manual provides essential information for the safe and efficient operation of your PowerBrite PB15 Pro.
تصوير: سامهون view of the Samson PB15 Pro PowerBrite Rackmount Power Center, showing the main power switch, voltmeter, ammeter, dimmer control, pull-out lamps, and unswitched outlet.
حفاظتي هدايتون
Please read and adhere to the following safety precautions to prevent damage to the unit or injury to yourself:
- هن يونٽ کي مينهن يا نمي کي ظاهر نه ڪريو.
- ڍڪ نه هٽايو. اندر ڪو به استعمال ڪندڙ-خدمت وارو حصو نه آهن. سڀني خدمتن جو حوالو ڏيو قابل عملدار کي.
- پڪ ڪريو ته يونٽ صحيح طور تي ٺهيل آهي.
- Do not overload the power conditioner. Refer to the specifications for maximum current draw.
- ڪو به ڪنيڪشن ٺاهڻ يا سار سنڀال ڪرڻ کان اڳ بجلي بند ڪريو.
- صرف مخصوص وولٽ استعمال ڪريوtage آپريشن لاء.
سيٽ اپ ڪريو
Follow these steps to set up your PowerBrite PB15 Pro:
- ريڪ لڳائڻ: The PB15 Pro is designed for standard 19-inch equipment racks. Secure the unit using appropriate rack screws. Ensure adequate ventilation around the unit.
- پاور ڪنيڪشن: Connect the integrated AC power cord from the PB15 Pro to a suitable grounded wall outlet. Verify that the voltage matches the unit's requirements (115 VAC as indicated on the front panel).
- سامان ڪنيڪشن:
- Connect your audio or electronic equipment to the 8 switched AC outlets located on the rear panel of the PB15 Pro.
- An additional unswitched convenience outlet is located on the front panel for equipment that requires constant power, regardless of the main power switch status.
- ڪيبل جو انتظام: Route all power cables neatly to prevent tripping hazards and ensure proper airflow.
آپريٽنگ هدايتون
Familiarize yourself with the controls and indicators on the front panel:
- Main Power Switch (OUTLETS ON/OFF): This large red rocker switch controls the power to the 8 rear-panel AC outlets. Flip it to the "ON" position to supply power to connected equipment. The front panel unswitched outlet remains active regardless of this switch's position.
- وولٽميٽر: The digital display labeled "VOLTMETER" shows the incoming AC line voltage, allowing you to monitor power conditions.
- ايميٽر: The digital display labeled "AMMETER" indicates the total current (amperes) being drawn by all equipment connected to the switched outlets. This helps prevent overloading.
- Dimmer ڪنٽرول: The blue knob labeled "DIMMER" adjusts the brightness of the two pull-out LED lamps.
- Pull-out LED Lamps: Two retractable LED lamps are located on the front panel. Pull them out to illuminate your rack equipment. Their brightness is controlled by the Dimmer knob.
- Unswitched Outlet (115 VAC): A single AC outlet on the front panel provides constant power, independent of the main power switch. Use this for equipment that needs to remain powered on.
- 15 AMP Circuit Breaker (PUSH TO RESET): Located on the left side of the front panel, this circuit breaker protects the unit from overloads. If the total current draw exceeds 15 amperes, the breaker will trip, cutting power to the switched outlets. To reset, push the button back in. Reduce the load before resetting.
سار سنڀال
The Samson PB15 Pro PowerBrite requires minimal maintenance. Follow these guidelines to ensure its longevity:
- صفائي: Disconnect the unit from power before cleaning. Use a soft, dry cloth to wipe down the exterior. Do not use liquid cleaners or solvents.
- وينٽيليشن: Ensure that the ventilation slots are not obstructed. Proper airflow is crucial for preventing overheating.
- ڪيبل جي چڪاس: Periodically inspect the power cord and all connected cables for any signs of damage or wear. Replace damaged cables immediately.
مشڪلاتون
If you encounter issues with your PowerBrite PB15 Pro, refer to the following common problems and solutions:
| مسئلو | ممڪن سبب | حل |
|---|---|---|
| No power to switched outlets. | مين پاور سوئچ بند آهي. سرڪٽ بريڪر ڀڄي ويو آهي. No incoming AC power. | Ensure the main power switch is ON. چيڪ ڪريو 15 AMP circuit breaker and reset if tripped. Reduce connected load. Verify the wall outlet has power. |
| LED ايلamps not illuminating. | Lamps not pulled out. Dimmer control set to minimum. | ايل اي ڊي کي ٻاھر ڪڍوampمڪمل طور تي. Rotate the Dimmer control clockwise to increase brightness. |
| Ammeter reading is high. | Excessive current draw from connected equipment. | Reduce the number of devices connected or use lower power consumption devices. Ensure total load does not exceed 15 Amperes |
وضاحتون
| خاصيت | تفصيل |
|---|---|
| پيداوار جي ماپ | 54.61 x 9.53 x 29.21 سينٽي |
| شيون ماڊل نمبر | SAM PB15PRO |
| شيءِ جو وزن | 3.86 ڪلوگرام (3 ڪلوگرام 860 گرام) |
| ٺاهيندڙ | سامسون |
| ASIN | B001B8ADV6 |
| تاريخ پهرين دستياب | 31 آڪٽوبر 2012 |
| عام نالو | پاور ڪنڊيشنرز |
| آئوٽليٽ | 8 rear-panel switched AC outlets, 1 front-panel unswitched convenience outlet |
| سرڪٽ بريڪر | 15 Amperes, push to reset |
| ميٽرڪنگ | Dual digital multi-meters (Voltmeter, Ammeter) |
| روشني | Two pull-out LED lamps with dimmer control |
وارنٽي ۽ سپورٽ
Specific warranty information for the Samson PB15 Pro PowerBrite is not provided in this manual. For detailed warranty terms, technical support, or service inquiries, please contact Samson Technologies directly or refer to their official webسائيٽ. وارنٽي دعوائن لاءِ خريداري جي ثبوت طور پنهنجي خريداري جي رسيد رکو.
