زيروڪس 7800/ڊي ايڪس فيز رنگين ليزر پرنٽر استعمال ڪندڙ دستياب

پيداوار ختمview

The Xerox 7800/DX Phase Color Laser Printer is designed for professional environments requiring high-quality color printing and robust performance. This printer offers advanced capabilities for graphic-intensive tasks, including industry-leading media flexibility and professional color management technologies.

شڪل 1: سامهون view of the Xerox 7800/DX Phase Color Laser Printer, showcasing ان جي ملٽي ٽري ڊيزائن ۽ ڪنٽرول پينل.

سيٽ اپ جون هدايتون

1. Unpacking ۽ لڳائڻ

• Carefully remove the printer from its packaging. Due to its weight (approximately 256 pounds), it is recommended to use appropriate lifting equipment or assistance.
• Place the printer on a stable, level surface capable of supporting its weight and dimensions (27.52 x 25.24 x 37.52 inches). Ensure adequate ventilation around the unit.

2. پاور ڪنيڪشن

• پاور ڪنڊ کي پرنٽر سان ڳنڍيو ۽ پوءِ گرائونڊ ٿيل اليڪٽريڪل آئوٽليٽ سان ڳنڍيو.
• پرنٽر کي چالو ڪرڻ لاء پاور بٽڻ کي دٻايو.

3. ٽونر ڪارٽريج جي انسٽاليشن

The Xerox 7800/DX uses separate toner cartridges for Black, Cyan, Magenta, and Yellow. Refer to the printer's internal diagrams for specific slot locations.

1. پرنٽر جو فرنٽ رسائي پينل کوليو.
2. Unpack each toner cartridge (compatible cartridges include 05R02801, 05R02802, 05R02803, 05R02804, 05R02805, 05R02806).
3. ٽونر کي هڪجهڙائي سان ورهائڻ لاءِ ڪارٽريج کي نرميءَ سان هلايو.
4. Insert each cartridge into its corresponding color-coded slot until it clicks into place.
5. سامهون واري رسائي پينل کي بند ڪريو.

شڪل 2: مثالample of an internal printer view, indicating where toner cartridges are typically installed.

4. پيپر لوڊ ڪندي

The printer features multiple paper trays with a maximum input sheet capacity of 3140 sheets.

1. Pull out the desired paper tray. The printer has 2 trays as standard.
2. Adjust the paper guides to fit the paper size. The printer supports various sizes, including 8.5 x 11 inch and up to 11 inches in width.
3. Load the paper (plain paper is supported) into the tray, ensuring it is flat and below the maximum fill line.
4. Gently push the tray back into the printer.
5. Confirm the paper type and size on the control panel if prompted.

5. سافٽ ويئر ۽ ڊرائيور جي انسٽاليشن

To enable printing from your computer, install the necessary drivers.

• The Xerox 7800/DX is compatible with PC, Mac, and Unix operating systems.
• سرڪاري زيروڪس سپورٽ تي وڃو webتوهان جي آپريٽنگ سسٽم لاءِ جديد ڊرائيور ڊائون لوڊ ڪرڻ لاءِ سائيٽ.
• انسٽاليشن مڪمل ڪرڻ لاءِ اسڪرين تي ڏنل هدايتن تي عمل ڪريو.
• Connect the printer to your computer via USB or Ethernet cable.

آپريٽنگ هدايتون

1. ڪنٽرول پينل اوورview

The printer features a touchscreen control panel for easy navigation and settings adjustment. Use the touch interface to access menus, check printer status, and configure print jobs.

شڪل 3: تفصيلي view of the printer's touchscreen control panel, showing various menu options.

2. بنيادي پرنٽنگ

1. اهو دستاويز کوليو جيڪو توهان پنهنجي ڪمپيوٽر تي پرنٽ ڪرڻ چاهيو ٿا.
2. ايپليڪيشن جي مينيو مان "پرنٽ" چونڊيو.
3. Choose the Xerox 7800/DX printer from the list of available printers.
4. Adjust print settings as needed, such as:
   • رنگ/مونوڪروم: The printer supports full color output with a maximum resolution of 1200 x 2400 dpi.
   • Duplex ڇپائي: خودڪار ٻٽي رخا ڇپائي جي حمايت ڪئي وئي آهي.
   • ڪاغذ جو ذريعو: Select the desired paper tray.
   • Copies: في رن 312 ڪاپيون تائين.
5. Click "Print." The printer has a maximum print speed of 45 pages per minute (ppm) for both color and monochrome. Initial page print time is 1-2 seconds.

3. ڪنيڪشن

• Ethernet: Connect the printer to your network using an Ethernet cable for shared access.
• USB: A single USB 2.0 port is available for direct connection to a computer.

سار سنڀال

1. Toner Replacement

When a toner cartridge is low or empty, the printer's control panel will display a notification. Replace cartridges as follows:

1. Open the front access panel.
2. خالي ٽونر ڪارٽريج کي احتياط سان سڌو ٻاهر ڪڍو.
3. Unpack a new, genuine Xerox toner cartridge of the correct color.
4. Shake the new cartridge gently.
5. Insert the new cartridge into the corresponding slot until it locks into place.
6. سامهون واري رسائي پينل کي بند ڪريو.

2. صفائي

• ٻاهران: ٻاھرين سطحن کي نرم سان صاف ڪريو، ڊيamp، لِنٽ کان پاڪ ڪپڙو. گھڙڻ واري صاف ڪندڙن کان پاسو ڪريو.
• اندروني: Periodically clean the interior of the printer, especially around the paper path and toner area, using a dry, lint-free cloth or a specialized printer vacuum. Refer to the printer's on-screen instructions for specific cleaning procedures.

مشڪلاتون

This section addresses common issues you might encounter. For more detailed troubleshooting, consult the full service manual or contact Xerox support.

عام مسئلا ۽ حل:

• پرنٽر جواب نه ڏئي رهيو آهي:
  • پاور ڪنيڪشن چيڪ ڪريو ۽ پڪ ڪريو ته پرنٽر آن آهي.
  • نيٽ ورڪ يا USB ڪيبل ڪنيڪشن جي تصديق ڪريو.
  • پرنٽر ۽ ڪمپيوٽر ٻئي ٻيهر شروع ڪريو.
  • پڪ ڪريو ته صحيح پرنٽر ڊرائيور انسٽال ٿيل ۽ چونڊيو ويو آهي.
• خراب پرنٽ معيار:
  • ٽونر جي سطح چيڪ ڪريو ۽ ڪنهن به گهٽ ڪارٽريج کي تبديل ڪريو.
  • Perform a print head cleaning or calibration from the control panel.
  • پڪ ڪريو ته توهان پنهنجي پرنٽ سيٽنگن لاءِ مناسب پيپر استعمال ڪري رهيا آهيو.
• پيپر جام:
  • Follow the on-screen instructions on the control panel to locate and clear the jam.
  • پڪ ڪريو ته ڪاغذ صحيح طرح سان ڀريل آهي ۽ ٽري ۾ وڌيڪ نه ڀريل آهي.
  • Remove any foreign objects from the paper path.

ٽيڪنيڪل وضاحتون

وارنٽي ڄاڻ

The Xerox 7800/DX Phase Color Laser Printer comes with a full manufacturer's warranty. For specific terms and conditions, please refer to the documentation included with your product or visit the official Xerox webسائيٽ.

اهم نوٽ: All returns must be authorized by Xerox Corp. No exceptions.

ڪسٽمر سپورٽ

For further assistance, technical support, or to access additional resources, please contact Xerox Customer Support or visit their official webسائيٽ.

توهان وڌيڪ معلومات ۽ سپورٽ وسيلا ڳولي سگهو ٿا Xerox Store on Amazon or the main Xerox corporate webسائيٽ.