FERM Air-Cooled Generator PGM1010 User Manual

تعارف

This manual provides essential instructions for the safe and efficient operation, maintenance, and troubleshooting of your FERM PGM1010 Air-Cooled Generator. Please read this manual thoroughly before operating the generator to ensure proper use and to prevent injury or damage.

حفاظتي هدايتون

Always observe the following safety precautions to reduce the risk of injury, electric shock, fire, and property damage.

• ڪاربن مونو آڪسائيڊ جو خطرو: Generators produce carbon monoxide, a colorless, odorless, poisonous gas. Operate the generator outdoors in a well-ventilated area, far from windows, doors, and vents. Never operate indoors or in enclosed spaces.
• باهه جو خطرو: ٻارڻ تمام گهڻو باهه لڳڻ وارو آهي. ٻارڻ کي سٺي هوادار علائقي ۾ انجڻ بند ۽ ٿڌو ڪري ٻيهر ڀريو. سگريٽ نه ڇڪيو ۽ جنريٽر جي ويجهو باهه نه ٻاريو. ٻارڻ کي منظور ٿيل ڪنٽينرن ۾ ذخيرو ڪريو.
• برقي جھٽڪو جو خطرو: Do not operate the generator in wet conditions. Ensure all electrical connections are secure and dry. Use only approved extension cords.
• گرم سطحون: The generator engine and muffler become very hot during operation and remain hot for a period after shutdown. Avoid contact with hot surfaces to prevent burns.
• ٻار ۽ پالتو جانور: ٻارن ۽ پالتو جانورن کي جنريٽر کان پري رکو، خاص ڪري آپريشن دوران.
• گرائونڊنگ: پڪ ڪريو ته جنريٽر مقامي اليڪٽريڪل ڪوڊس جي مطابق صحيح طرح سان گرائونڊ ٿيل آهي.
• اوور لوڊ تحفظ: Do not overload the generator. The PGM1010 has an overload switch for safe working.

پيداوار ختمview ۽ اجزاء

Familiarize yourself with the main components of your FERM PGM1010 generator.

تصوير: سامهون view of the FERM PGM1010 generator, showing the control panel with the AC outlet, AC protector switch, and engine start/stop switch. The pull-start handle is visible on the right side.

• ٻارڻ جي ٽانڪي ڪيپ: Located on top, for adding fuel.
• ڇڪڻ وارو شروع هينڊل: دستي طور تي انجڻ شروع ڪرڻ لاء استعمال ڪيو ويو.
• AC آئوٽليٽ: For connecting electrical devices.
• AC Protector Switch (Circuit Breaker): Protects against overload. Resets after tripping.
• انجڻ سوئچ: Controls engine operation (ON/OFF).
• هٿ کڻڻ: آسان ٽرانسپورٽ لاء.
• Shock Absorbing Feet: Reduces vibration during operation.

سيٽ اپ ۽ تياري

1. پيڪنگ کولڻ: جنريٽر کي احتياط سان ان جي پيڪنگ مان هٽايو. ڪنهن به شپنگ نقصان جي چڪاس ڪريو.
2. لڳائڻ: Place the generator on a firm, level surface outdoors in a well-ventilated area, away from combustible materials and at least 1 meter (3 feet) from buildings or other equipment.
3. ٻارڻ:
   • The PGM1010 uses a gasoline and oil mixture (50:1 ratio).
   • Mix unleaded gasoline with 2-stroke engine oil in a separate, approved fuel container.
   • پڪ ڪريو ته انجن بند آهي ۽ تيل ڀرڻ کان اڳ ٿڌو آهي.
   • Open the fuel tank cap and carefully pour the fuel mixture into the tank. Do not overfill.
   • ايندھن جي ٽانڪي جي ڪيپ کي محفوظ طور تي بند ڪريو.
4. گرائونڊنگ: Connect a grounding wire from the generator's grounding terminal to a suitable ground source, as per local electrical regulations.

آپريٽنگ هدايتون

جنريٽر شروع ڪرڻ:

1. پڪ ڪريو ته سڀئي بجلي جا سامان جنريٽر کان ڌار ٿيل آهن.
2. انجن جي سوئچ کي "آن" پوزيشن تي سيٽ ڪريو.
3. If the engine is cold, apply choke (refer to specific choke lever location on your unit, usually near the carburetor).
4. Pull the starter handle firmly and smoothly until the engine starts. Do not let the rope snap back.
5. Once the engine starts, gradually push the choke lever back to the "OFF" position as the engine warms up.
6. Allow the generator to run for a few minutes to stabilize before connecting electrical loads.

برقي لوڊ سان ڳنڍڻ:

• Plug your appliances into the AC outlet.
• Do not exceed the rated output of 700 W or the maximum output of 800 W. Overloading will trip the AC protector switch.
• If the AC protector switch trips, disconnect some appliances, then press the "RESET" button on the switch to restore power.

جنريٽر بند ڪرڻ:

1. جنريٽر مان سڀ بجليءَ جي سامان کي ڌار ڪريو.
2. جنريٽر کي ڪجهه منٽن لاءِ بغير لوڊ ڪرڻ جي ٿڌو ٿيڻ جي هلڻ ڏيو.
3. Set the engine switch to the "OFF" position.

سار سنڀال

باقاعده سار سنڀال توهان جي جنريٽر جي ڊگهي عمر ۽ قابل اعتماد آپريشن کي يقيني بڻائي ٿي.

• اسپارڪ پلگ: Inspect and clean the spark plug regularly. Replace if worn.
• ايئر فلٽر: Clean the air filter element periodically. Replace if damaged.
• ٻارڻ فلٽر: Check and clean the fuel filter as needed.
• ٻارڻ جو نظام: If storing the generator for an extended period, drain the fuel tank and carburetor to prevent fuel degradation and clogging.
• عام صفائي: Keep the generator clean and free of dirt and debris. Use a dry cloth to wipe down surfaces.
• اسٽوريج: Store the generator in a clean, dry, well-ventilated area, away from direct sunlight and extreme temperatures.

مشڪلاتون

جيڪڏهن انهن حلن جي ڪوشش ڪرڻ کان پوءِ به مسئلا برقرار رهن ٿا، مهرباني ڪري ڪسٽمر سپورٽ سان رابطو ڪريو.

ٽيڪنيڪل وضاحتون

• ماڊل نمبر: پي جي ايم 1010
• قسم: جنريٽر
• طاقت جو ذريعو: پيٽرول
• ماتحت پاسو 700 ڊبليو
• وڌ ۾ وڌ پيداوار: 800 ڊبليو
• AC موجوده: 3 اي
• انجڻ: هوا ۾ ٿڌل، 2-اسٽروڪ
• ٻارڻ: Gasoline and oil mixture (50:1)
• ٽينڪ جو حجم 4.5 ليٽر
• Operating Hours (full tank): لڳ ڀڳ 8 ڪلاڪ
• مجموعي وزن: 17.06 ڪلو
• شيء جو وزن: 17.1 ڪلوگرام
• پيڪيج جي ماپ: 61 x 35 x 1.6 سينٽي
• خاص خاصيتون: Portable, Overload switch, Shock absorbing feet
• ٺاهيندڙ: فرم
• اصل: چين

وارنٽي ۽ سپورٽ

For warranty information, technical support, or service inquiries, please refer to the documentation provided with your purchase or contact your local FERM dealer or customer service center. Keep your purchase receipt as proof of purchase.