JoJo Booster Pump Flow Controller

وضاحتون

• پيداوار جو نالو: JoJo Booster Pump Flow Controller
• سان مطابقت: JoJo Booster Pumps
• متبادل حصو: JoJo PC Board
• اوزار گهربل: STAR SCREW DRIVER

توھان کي ھيٺين جي ضرورت پوندي:

نوٽ: Our Booster Pump PC Board is only suited for use with the following JoJo

Booster Pumps:

•  0.37kW بوسٹر پمپ
•  0.55kW, 0.75kW & 1.1kW
• سينٽرفيوگل پمپ
•  0.6kW سيلف پرائمنگ جيٽ پمپ

پيداوار جي استعمال جون هدايتون

قدم 1
Ensure that your pump is disconnected from the power source.

قدم 2
Unscrew the four screws holding the terminal box cover in place.

قدم 3
ٽرمينل باڪس جو Removeڪ هٽايو.

قدم 4
Disconnect the wires from the terminals and remove from the terminal box.

قدم 5
Unscrew the two screws holding the PC Board in place.

قدم 6
PC بورڊ کي هٽايو.

قدم 7
Insert the replacement JoJo PC Board.

قدم 8
Insert and fasten the two securing screws on both sides of the PC Board.

قدم 9
Secure the wires to the terminals as follows:

•  the wires from the pump through the bottom grommet
• the wires from the three-point plug through the top grommet.
  نوٽ: ensure that the correct color sequence is followed as shown below

قدم 10
Replace the terminal box cover, and fasten the four screws holding it in place.

قدم 11
Your pump is now ready for use and reconnection to your power supply.
Scan the QR Code to watch the instructional video for visual guidance.

www.jojo.co.za

FAQ

Can I use the JoJo Replacement PC Board with other pumps?

Our Booster Pump PC Board is only suited for use with JoJo Booster Pumps.

دستاويز / وسيلا

JoJo Booster Pump Flow Controller [pdf] استعمال ڪندڙ ھدايت Booster Pump Flow Controller, Pump Flow Controller, Flow Controller, Controller

حوالو

• استعمال ڪندڙ دستي